HES-80-4090-412

The DROMONE Ball & Spoon Coupling System offers the quietest towing experience when compared to conventional hook and ring systems. 90% less wear and hitch damage compared to using traditional towing rings, reducing your operating costs.

IMPORTANT: information on fitting and using Weld on Spoon

WARNING – Ensure spoon is preheated (~200C) prior to welding. Following welding, the spoon and weld area is to be annealed by heating to (~150C) and allowing to cool at air temperature.

Welding Instructions:

• Ensure the welding area of the spoon is preheated to ~200° C prior to welding.
• Following welding the area is to be annealed by heating to ~ 150° C and
• allowed to cool at air temperature.
• Also importantly ensure the CUP area is covered to prevent weld spatter and debris entering as this will cause premature wear and scoring within a short term of use.
• It is also advised not paint the cup area.

Recommended Welding Size:

• 15mm leg length (Min.12mm) along both sides (Min 250mm), and across the back of the hitch. DO NOT WELD across the front of the hitch.

Greasing:

• Before first coupling of the Spoon and Ball ensure Ball and spoon are greased thoroughly and when coupled, further grease using the grease nipple on the spoon and thereafter at regular intervals during use.